Level and square
Stone does not flex the way laminate does. If a run of boxes has settled or was set out of level, we shim it before we template, so the new top sits flat and seams close tight.
Fletcher Countertop Upgrades on the Cabinets You Have
Henderson Custom Countertops replaces builder-grade countertops in Fletcher, NC as a leading Henderson County installer, specializing in granite upgrades, quartz kitchens and clean tear-outs of worn laminate countertops. We offer quartzite islands and matching bathroom vanity tops.
- No-cost measure at your home
- You approve the slab
- Itemized written quote
Countertops for Fletcher
Our team provides careful removal of the old tops, delivering new stone over the cabinets you already own for both residential and commercial projects. Our own installers check every box for level and square before we template, and the same crew that took the measurements is the one that sets the stone.
From prying off a post-formed laminate top without cracking the face frames to a finished granite or quartz kitchen with a vanity to match, our team handles every detail. Serving Fletcher as well as Mills River, Hendersonville and Flat Rock, we book the measure around your working week and write the install date on the estimate.
Why Henderson Custom Countertops
What You Can Hold Us To
Whoever measures your cabinets is the person accountable for the finished top.
On-site measureEvery wall and cabinet measured and checked for level before cutting
Your slabYou approve the exact slab and where each seam lands
Written scopeMaterial, edge, cutouts and backsplash listed line by line
Licensed, bonded & insuredProof of insurance on request; a COI and W-9 with every commercial bid
The builder-grade kitchen in a Fletcher subdivision
Most Fletcher kitchens that need new tops still have the ones the builder put in: post-formed laminate, or a thin entry-level granite with a small backsplash strip. Fletcher was settled in 1795 but stayed small until a burst of growth from roughly 1980 to 2000, and it only incorporated as a town in 1989. The town's own history puts that growth down to location: between Hendersonville and Asheville, along a major interstate and right next to the area's largest airport.
A house from that boom is now old enough for its original surfaces to show their age. Here is what to look for:
- Swelling at the sink seam. Post-formed laminate is a thin sheet glued over a particleboard substrate, and once water gets into the core, it puffs and will not go back.
- Lifted or chipped edges where the laminate has let go of the board.
- Burns and knife cuts, since laminate is kraft paper and melamine resin, not stone.
- Entry granite in a colour that dates the room, often with a four-inch splash and a thin, eased edge.
- Tile tops with grout lines that never come clean.
None of that means the kitchen is finished. In a lot of these houses the cabinets are the part still in good shape.
Keeping the cabinets you have
Sound builder cabinets can usually carry a stone upgrade, and keeping them is the single biggest saving in a Fletcher kitchen. What we check at the measure decides whether that is true for yours.
The sink base
A slow leak under the sink is common in a kitchen of this age. If the floor of that cabinet is soft, it is replaced before new stone goes on.
Box construction
Particleboard boxes with a sound face frame will hold stone when the load is spread. Where an overhang or a peninsula extends past the boxes, we add supports under it.
Height and depth
Finished counters in the US sit at about 35 to 36 inches and run about 25 to 26 inches deep over standard base cabinets. Stone may be a little thicker than your laminate, so we tell you at the measure exactly where the new surface will land against the range and the window sill. One more choice: your tile backsplash. Lifting the old top can crack the bottom row, so decide at the measure whether to keep the tile and accept a touch-up, or go with a new splash of stone or tile.
What a Fletcher upgrade costs
Replacing builder-grade countertops in a Fletcher kitchen is typically estimated at roughly $2,500 to $7,000 including tear-out, depending mostly on size and the stone you pick. By material, installed granite is usually estimated at about $40 to $100 per square foot and quartz at about $60 to $150 per square foot. A matching bathroom vanity top adds roughly $500 to $2,000 per vanity as an estimate.
The things that move a Fletcher number:
- Square footage and whether the job needs one slab or two.
- Material and grade, from a common granite to a premium quartz.
- Tear-out. Laminate lifts off quickly; tile set on a mortar bed takes longer.
- Cabinet work, such as shimming, a new sink base floor or overhang supports.
- Edge profile, thickness and the number of cutouts.
- Backsplash height, from a short splash to a full run of stone.
These are estimates from regional ranges, not a quote, and they are subject to change with slab prices and what the measure finds. The written quote you get after the free measure sets the final price.
Choosing the upgrade: granite, quartz or quartzite
For a Fletcher builder-grade upgrade, granite gives the best value, quartz gives the most even look, and quartzite gives natural stone with the hardest wear.
Granite
A coarse igneous rock of quartz, feldspar and mica, granite handles heat and knives well. Like other natural stone, it is sealed to keep it from holding stains.
Quartz
Engineered quartz is roughly 93 percent crushed stone bound in resin. Testing has found it the most resistant of common household surfaces to discoloration from food and cleaning products, which suits a busy family kitchen.
Quartzite
A metamorphic rock that began as quartz sandstone, quartzite is harder than granite and is a popular pick for an island that becomes the centre of the room. Whichever you pick, we send you to a supplier's yard to see full slabs, then lay out the seams on the slab you choose before it is cut.
New homes going up in Fletcher
Fletcher is still growing, and new subdivisions bring builder work as well as homeowner upgrades. In 2022 the town approved several new subdivisions, on Rutledge Road and Cane Creek Road, along with apartments such as The Groves at Town Center. Town Hall is on Old Cane Creek Road, where the planning and zoning office handles those reviews.
For a builder, the work looks different. A selection sheet fixes the material, edge and sink for each floor plan, and we template each house only after its cabinets are set. If you are building in Fletcher, our builder packages page covers that process; send the plans and selections for a bid. If you have just bought a new house here and do not love the tops, we can quote the swap right after closing.
Scheduling around I-26 work
A Fletcher install is planned around the interstate, because slabs come in on a truck and I-26 is being widened past the town. NCDOT's project covers about 16.9 miles of I-26 from US 64 in Hendersonville to Brevard Road in Asheville, and its first section runs from Exit 49 west to NC 280 at Exit 40, the Airport Road interchange. Construction began in the fall of 2019.
Interstate 26 passes along the west side of Fletcher with Exits 40 and 44, and US 25, Hendersonville Road, runs through the middle of town. On install day we pick the route to your street based on current lane closures and call you if traffic changes the arrival time. For you, the only change is a little flexibility in the morning window.
Stone, Edges and Finishes
Where we work
Other Communities We Cover
Straight answers
Fletcher Countertop Questions
Can new stone go on my existing Fletcher cabinets?
Usually, yes. If the boxes are sound, level and dry under the sink, they will carry granite, quartz or quartzite, and we shim or add supports where the measure shows a need.
Will taking off the old laminate damage my tile backsplash?
It can crack the bottom row of tile, because the old top is often caulked or tucked under it. We lift it carefully, and at the measure we talk through keeping the tile with a touch-up or moving to a new splash.
Is it worth replacing entry-level granite?
It is when the colour dates the kitchen, the edge is thin, or the seams have opened. If the stone is simply dull, a clean and reseal may be enough, and we will tell you so.
How much does it cost to replace countertops in Fletcher?
A Fletcher kitchen replacement is typically estimated at roughly $2,500 to $7,000 including tear-out. Those figures are estimates and subject to change; the written quote after your free measure sets the final price.
Do I need to empty my cabinets before install day?
Clear the countertops and the sink base, and take anything fragile out of the upper cabinets near the work. The lower drawers can usually stay loaded.
Who reconnects the sink and dishwasher?
A licensed plumber disconnects and reconnects them, since plumbing is its own licensed trade in North Carolina. We set the sink and cut the faucet holes so that visit is quick.
Can you match a bathroom vanity to the new kitchen?
Yes. A vanity can often be cut from the same slab or from a remnant of the same stone, and it goes in on the same install visit as the kitchen.
Do you work with builders on new Fletcher subdivisions?
Yes, as the countertop subcontractor. Send the floor plans and selection sheet and we return a plan-by-plan bid, then template each house once its cabinets are set.
No-cost site visit
Ready to Talk About Countertops in Fletcher?
We measure homes and businesses across Henderson County. Builders and businesses can send drawings for a bid.
Licensed, bonded & insured. Calls only, we do not receive text messages.