Granite
Chips and hairline cracks are filled and polished, and the speckle in the stone helps hide a color-matched patch.

Henderson Custom Countertops offers countertop repair in Hendersonville, NC, for chipped, cracked and separated countertops, and tells you plainly when a fix will not hold. Most single repairs cost far less than a new top, and the first look is free.
Most countertop damage is repairable when it is caught early, and a good repair is invisible at arm's length. ee rebuild chipped edges, bond cracks, re-set opened seams and bring dull spots back to the sheen around them, on stone and on engineered tops.
ee will also say so when repair is the wrong answer. A top that has split clear through, or one failing in several places, is usually better replaced, and we would rather tell you that at the first visit. Repairs are available around Hendersonville, from Flat Rock out to Mills River.
Why Henderson Custom Countertops
Whoever measures your cabinets is the person accountable for the finished top.
Chips, hairline cracks, opened seams, dull spots and heat marks are the damage we repair most. Each has a different cause, so each gets a different fix.
Chips usually happen at an edge or around a sink opening, where a dropped pot or a hard knock removes a small piece. The break is rebuilt with a two-part epoxy or resin tinted to the stone, shaped back to the original profile and polished.
Cracks are more serious because they tell you the stone was stressed. A crack that starts at the corner of a sink or cooktop opening is common, since those corners hold the thinnest section of the slab. A hairline crack can be cleaned, bonded with epoxy and reinforced from underneath so the top carries weight again.
Seams open for two reasons: cabinets shifting, or a joint that was never fully bonded. ee re-level the pieces, re-bond them and tool the joint flush.
Repair stops making sense when a crack runs the full width of a span, when a piece has broken in two, or when an old top shows several separate failures. At that point you would be paying for repairs on stone that will keep failing, and replacement is the honest answer.
Countertops crack because stress finds the weakest point, and the weakest point is almost always a narrow section of stone. Understanding the cause is how you avoid paying for the same repair twice.
The usual causes we see are these:
ehen we repair a crack, we look at the reason behind it. If the cabinet is out of level or a span is unsupported, we fix that as part of the job, because bonding a crack over an unresolved stress just sets up the next one.
For stone with a history of cracking, a trivet by the cooktop and a support bracket under any wide overhang are the two cheapest forms of insurance you can buy.

Most single countertop repairs in Henderson County are estimated between roughly $120 to $650, which is a fraction of the cost of replacing the top. The range reflects the material, how visible the damage is and how much surrounding surface must be blended.
Three things move the number most. The first is the material, since marble and soft stone are simpler to blend than a busy granite. The second is visibility: a chip on the back edge near the wall costs less effort than one at the front of an island. The third is the polish blend, meaning how much of the neighboring surface has to be re-finished so the repair vanishes.
These are estimates. A clear photo lets us narrow the range before a visit, and the written quote after we see the damage in person sets the final price.
A single repair usually takes one visit lasting an afternoon at most, and the surface wants gentle use for a day while the bond cures. ee do the work at your counter so nothing has to be unbolted or hauled away.
The order matters, because a repair that skips a step looks fine for a month and then fails. ee clean and dry the area first, since oil, soap film and moisture stop epoxy from gripping. For a crack, we open the line slightly so the epoxy can flow deep rather than sit on the surface.
Then the material goes in. ee use a resin or two-part epoxy mixed and tinted on site to the stone color, and where there is veining we add the vein by hand. Once it cures, the patch is sanded level and polished through progressively finer abrasives until the sheen matches the area around it.
Natural stone gets a fresh coat of sealer over the repaired spot, so the patch resists stains the same way the rest of the top does.
Color matching is the part you can judge. On a busy granite with lots of speckle, a repair nearly disappears. On a plain solid color, a faint line can sometimes be seen from very close, and we tell you that before we start.

Each material fails in its own way and repairs in its own way. ee choose the filler, the abrasives and the finish to suit the stone in front of us.
Chips and hairline cracks are filled and polished, and the speckle in the stone helps hide a color-matched patch.
Seams and chips can be filled and refinished, while heat scorching depends on how deep the resin has changed.
Etching, a dull ring where acid has reacted with the calcite, is honed out and the area is re-polished and sealed.
A very hard stone, so repairs take patience and sharp abrasives, but chips and seams are well within reach.
Scratches and small chips sand out easily, and an oil or wax finish blends the area back in.
Because the color runs through the material, scratches and burns can be sanded out and blended without a visible patch.



Start to finish
You know the plan and the estimated price before any work begins.
ee inspect the damage in person or from photos, check the cabinet beneath it, and tell you if it can be repaired.
The area is cleaned and dried, and cracks are opened slightly so the bond can reach full depth.
A color-matched epoxy or resin goes in, with veining added by hand where the stone has it.
The patch is leveled and polished to match the sheen, and natural stone is sealed over the repaired spot.
Straight answers
Usually, yes. A hairline or stress crack can be cleaned, bonded with color-matched epoxy and reinforced from underneath. A crack that runs the whole width of a span, or a piece that has broken in two, is a replacement job.
On busy, speckled stone it nearly disappears. On a plain solid color, a faint line may show from very close. ee tell you what to expect before we start.
Yes, chips at the sink and along edges are among the repairs we do most. The missing material is rebuilt, the edge is re-shaped and polished, and the corner ends up smooth under your hand.
Usually. An etch is a pale, dull patch left when something acidic has eaten into the calcite in the stone. ee hone the area and re-polish it, then reseal, though a deep etch may leave a faint trace.
Repair when the damage is isolated and the rest of the top is sound. Replace when failures are widespread or the stone is structurally compromised, and we will say which one applies at the first look.
Most repairs wrap up in one visit lasting an afternoon at most, then the spot wants gentle use for about a day while the bond cures. A long crack with reinforcement can take longer.
Most single repairs are estimated between roughly $120 to $650, depending on the material and the damage. A photo helps us narrow that, and the written quote after the visit sets the final price.
For a repair, yes. The filler is tinted on site against your existing stone, so a discontinued slab is not a barrier to a patch.
We measure homes and businesses across Henderson County. Builders and businesses can send drawings for a bid.
Licensed, bonded & insured. Calls only, we do not receive text messages.